During the operation of the crusher, some unexpected failures often occur, and the material blocking and tripping is one of them. When the crusher malfunctions, friends should not panic. All you have to do is to find out the cause, cure the "sickness" of the crusher, and prescribe the right medicine.
    The crusher "eats too much and can't digest it", and it's not a big problem that jamming s s. Jiaozuo Zhongxin tells everyone that the main reason for the crushing and blocking of the crusher is that there is too much material in the small cavity of the crusher to be discharged, and the moving cone is resisted, causing the motor to overload and s . There are usually two situations that cause a trip.
    1. The output of the crusher is high, and the belt conveyor at the lower discharge port is too late to be pulled away, causing blockage;     2. The downstream equipment jumps and s s, and the crusher continues to crush. Once this happens, all the materials in the crushing chamber be sorted out before the machine can be started. Generally, it takes at least 3 hours to .
    In order to prevent the material from jumping and s ping, the sound and light indicator method is used to directly indicate the material dumping, which has a good effect. Moreover, it is very important that the alarm current value of the slat conveyor should be set appropriately, not too low or too high. If it is too low, the crusher will often break the material, and the stone will hit the slab conveyor; if the setting is too high, the lower cavity will have a lot of material, and the buffer space will not be enough. If the downstream equipment fails, it will easily cause the crusher to block the material. Practice has proved that the appropriate setting value guarantees the continuous and stable discharge of the crusher, and also leaves enough buffer space for the lower cavity of the crusher, which can effectively prevent the material from being blocked and s ped.