The vibrating feeder is the source of the entire production line. If there is a material blocking and sprinkling, it may cause the stone production line to be paralyzed in severe cases. Therefore, it is very important to ensure the normal operation of the vibrating feeder. So what are the reasons for the material blocking, sprinkling and non-feeding of the vibrating feeder, and how can we avoid failures and ensure the normal operation of the equipment? 1. Judging from the characteristics of the material itself, the main reason for the blockage of the vibrating feeder is the high viscosity and moisture. Due to the reduced fluidity of the material, this will cause the usual "wall hanging" and "shed material" phenomena after the material enters the warehouse, especially during the rainy season. The gap between the iron core of the feeder and the armature is too large or too small. If this happens, it will affect the feeding of the feeder because the machine cannot reach the normal amplitude.
  2. It may be caused by excessive feeding, causing accumulation of materials in the machine base, increased lifting force of the screw conveyor, and poor operation of the hopper. In this case, the amount of feeding should be reduced immediately and maintained Feed evenly.