Sand making machine is an indispensable equipment in the sand making production line. How to improve the production efficiency of the equipment is a problem that enterprises are constantly pursuing. Today, Jiaozuo Zhongxin summarizes the following 5 methods to improve the production efficiency of sand making machines for our customers. Sand making machine
    1. Installation position of sand making machine accessories: The pressure and flow rate inside the cavity can improve production efficiency. However, under the condition that the two premises remain unchanged, the sand making machine accessories should be installed in place as much as possible. For example, the height of the grinding roller and grinding ring should be kept level, and the eccentric rubber sleeve can be used to adjust to the level; between the blade of the shovel and the grinding roller, a gap of about 10cm should be maintained, and the angle of 23 degrees should be maintained with the grinding bottom.
    2. The influence of the humidity of the material: Most mills on the market have good powdering effect, fast speed and high efficiency for dry, brittle and low water content materials; on the contrary, they are sticky and soft, sticky and hard, containing Materials with a large amount of water can easily stick to the blade of the shovel, resulting in poor machine operation and low production efficiency.
    3. Uniform feeding: The feeding speed often enters a misunderstanding. The larger the amount, the better, the output will increase. This is not the case; the one-time load is too large, which will cause the machine to operate poorly, as the saying goes, choking, or even sand making The machine s s; therefore, the feeding should follow the principle of uniform feeding, not too large or too small.
    4. Bearing lubrication: Lubricate the bearings of the sand making machine regularly to maintain lubrication and operate normally to prevent breakage.
    5. Lower pressure valve: Only press down, never lift up, otherwise the mill will leak air. It will take about five minutes for the pressure in the cavity to be sufficient to continue discharging.